01
Phone Triage
You call (833) 929-5837 and describe what you are seeing: black spots on caulk, a musty smell, peeling paint above the shower, or mold after a leak. We ask three or four questions, give you a ballpark range, and book a same-day or next-morning inspection. No call center, no runaround.
02
On-Site Inspection
A certified inspector walks the bathroom with a moisture meter and thermal imaging camera, checks under the vanity with a boroscope inspection camera, and looks at the ceiling below if there is one. This takes 30 to 45 minutes. You get photos, moisture readings, and a written scope before anyone touches a tool.
03
Containment and Removal
We tape up containment plastic sheeting, install a HEPA air scrubber, and suit up in personal protective equipment and respirators. Contaminated drywall, insulation, and caulk come out in sealed bags. Most bathroom jobs take four to eight hours of active removal, depending on how far the drywall mold contamination has spread.
04
Treatment and Encapsulation
Framing and remaining substrates get treated with an antimicrobial solution, then coated with an encapsulant. We use products from Fiberlock, Concrobium, and RMR Solutions depending on the surface. Grout lines and shower pans get a final pass with dry ice blasting to lift staining without abrasives.
05
Clearance Testing
Before we pull containment, we run a spore trap sampler in the bathroom and in an adjacent room. You get the lab report in 24 to 48 hours. If the numbers are not at or below outdoor baseline, we re-treat at no additional cost. That report is also what your insurance adjuster will want to see.